Suitability of non-metallic products for use in contact with water intended for human consumption with regard to their effect on the quality of water - Methods of test - Growth of aquatic micro-organisms test Ingestion-build-256245

Suitability of non-metallic products for use in contact with water intended for human consumption with regard to their effect on the quality of water - Methods of test - Growth of aquatic micro-organisms test Ingestion-build-2562451 Scope This section of BS 6920 specifies a method for assessing the ability of a product to promote the multiplication of aerobic aquatic microorganisms in water intended for human consumption. The method is applicable to all types of non metallic product used in contact with water intended for human consumption. NOTE Under the relevant National Regulations [3] to [9], the National Regulator may specify additional provisions in some cases and will

It can also be used to print hotel over door hangers

With obedience and compliance to BS EN 14399-8

For higher pressures

Series B: lifts for goods (freight) only

Information on typical construction (when applicable)

and liquid- and dry-toner electrophotographic digital prints

such as manufacturers of energy-related products (including SMEs) and other organisations in the product supply chain

BS EN 13121-2 defines the requirements for the protective layer and the structural laminate as well as defining methods for proof of suitability to meet the chemical/thermal effects caused by the fluids and of determination of the partial design factor

— metadata describing the attributes of each data element

It does not apply to mountain bicycles and racing bicycles

and suppliers of linen (flax) fabric and serrated edge strip

It complements BS 8515